Alcatel-Lucent 7750 SR Manual page 1799

7750 SR OS Services Guide
Label
SDP Delivery Mech-
anism
Max Drop Count
Number of SDPs
Service Access Points
Service Id
Port Id
Description
Encap Value
Admin State
Oper State
Last Changed
Admin MTU
Oper MTU
Ingress qos-pol-
icy
Egress qos-policy
Ingress Filter-Id
Egress Filter-Id
Multi Svc Site
Ingress sched-
policy
Egress sched-pol-
icy
Acct. Pol
Collect Stats
SAP Statistics
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far end field.
If the SDP type is GRE, then the following message displays:
SDP delivery mechanism is not MPLS
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
The total number SDPs applied to this service ID.
The service identifier.
The ID of the access port where this SAP is defined.
Generic information about the SAP.
The value of the label used to identify this SAP on the access port.
The desired state of the SAP.
The operating state of the SAP.
The date and time of the last change.
The desired largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end router, without requiring the packet
to be fragmented.
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
The SAP ingress QoS policy ID.
The SAP egress QoS policy ID.
The SAP ingress filter policy ID.
The SAP egress filter policy ID.
Indicates the multi-service site that the SAP is a member.
Indicates the ingress QoS scheduler for the SAP.
Indicates the egress QoS scheduler for the SAP.
Indicates the accounting policy applied to the SAP.
Specifies whether accounting statistics are collected on the SAP.
VPRN Show Commands
Description
Page 1799