Alcatel-Lucent 7750 SR Manual page 1300

VPRN Service Configuration Commands
arp-timeout
Syntax arp-timeout seconds
no arp-timeout
Context config>service>vprn>interface
config>service>vprn>sub-if>grp-if
Description This command configures the minimum time in seconds an ARP entry learned on the IP interface will
be stored in the ARP table. ARP entries are automatically refreshed when an ARP request or
gratuitous ARP is seen from an IP host, otherwise, the ARP entry is aged from the ARP table. If arp-
timeout is set to a value of zero seconds, ARP aging is disabled.
The no form of this command restores arp-timeout to the default value.
Default 14400 seconds
Parameters
seconds — The minimum number of seconds a learned ARP entry will be stored in the ARP table,
authentication-policy
Syntax authentication-policy name
no authentication-policy
Context config>service>vprn>if
config>service>vprn>sub-if>grp-if
Description This command assigns an authentication policy to the interface.
The no form of this command removes the policy name from the group interface configuration.
Default
no authentication-policy
Parameters
name — Specifies the authentication policy name. If the string contains special characters (#, $,
delayed-enable
Syntax delayed-enable seconds [init-only]
no delayed-enable
Context config>service>vprn>sub-if
Description
This command delays making interface operational by the specified number of seconds.
In environments with many subscribers, it can take time to synchronize the subscriber state between
peers when the subscriber-interface is enabled (perhaps, after a reboot). To ensure that the state has
time to be synchronized, the delayed-enable timer can be specified. The optional parameter init-only
can be added to use this timer only after a reboot.
Page 1300
expressed as a decimal integer. A value of zero specifies that the timer is inoperative and learned
ARP entries will not be aged.
Values
0 — 65535
spaces, etc.), the entire string must be enclosed within double quotes.
7750 SR OS Services Guide