8 Part replacement instructions
2. Remove the screws (four pcs).
3. Lift off the board.
4. Put the new board in its place.
5. Insert and tighten the screws (four pcs).
6. Connect the cables.
8.3.9 Replacing the tube head
CAUTION! Do not attempt to remove remove any parts, such as the circuit
board, from the tube head. The oil of the tube head can leak out.
NOTICE! You must remove the rotator back and front covers and the tube head
front and back covers before this procedure.
NOTICE! Remove the collimator before this procedure.
Required tools: Allen key 3mm, screwdriver
130
ORTHOPANTOMOGRAPH
™
OP 3D