I3000 Main Control Board - KaVo ORTHOPANTOMOGRAPH OP 3D Service Manual

i2000 fuses
Location
i2000
i2000
i2000
Replacing the i2000 image board
To replace the board, follow the instructions given in chapter
capture board.

4.5.2 i3000 Main control board

The i3000 main control board is located on top of the upper shelf. See figure
circuit boards.
The i3000 board is the main controller of the OP 3D X-ray imaging system. The main
features of i3000 board are listed below.
Functionality
The main functions of the i3000 Main control board are:
• Main control of the system
• Linear and pivot motion drive and position sensing
• Exposure control
• Image data streaming between i2000 and MWS
• Audio output
• User interfaces
• Remote GUI through LAN
• I4000 and i2000 firmware & FPGA updates.
ORTHOPANTOMOGRAPH
Ref Value
F1 FUSE slow 4A
250Vac 5x20 mm
F2 FUSE slow 6.3A
250Vac 5x20mm
F3 Resettable Fuse
PPTC 16V, 0.25A,
Itrip 0.5A
™
OP 3D
Type
Cooper Bussmann
S506-4-R
Cooper Bussmann
S506-6.3-R
Cooper Bussmann
PTS120616V025
Replacing the i2000 image
4 Device description
Replaceable
Yes
Yes
No
Locations of
37