Replacing The Mains Switch - KaVo ORTHOPANTOMOGRAPH OP 3D Service Manual

8 Part replacement instructions
3. Pull the board partly out.
4. Detach the connectors of the board.
5. Pull the board completely out.
6. Push the new board partly in.
7. Connect the connectors of the board.
8. Push the board completely in.
9. Connect the connector.
10. Insert and tighten the two screws.

8.3.19 Replacing the mains switch

1. Disconnect the J4107 connector.
™
ORTHOPANTOMOGRAPH OP 3D 149