Replacing The Led Lamp Of The Kl 703 Motor - KaVo ELECTROmatic M Instructions For Use Manual

▶ Clean the union nut and the surface of the filter insert.
▶ Tighten the union nut and check the filter for leakage.

9.2 Replacing the LED lamp of the KL 703 motor

Danger from hot lamp.
Risk of burn injury.
▶ Do not touch lamp after previous operation. Let the lamp cool off.
▶ Pull the sleeve off while twisting slightly.
▶ Push the old KaVo Mini LED lamp out of the mount with your fingernail and
remove it.
▶ Inset the new KaVo Mini LED lamp into the recess such that the contact
surfaces align with those of the mount. Slide the lamp into the mount. Place
the sleeve on the motor and pull it up.
Note
The KaVo Mini LED lamp is a semiconductor element and must be operated
with direct current only. The lamp must be inserted with the poles in the cor-
rect orientation for the lamp to work properly.
LED lamp inserted in wrong position/with wrong polarity.
Damage to or bending of the contacts.
▶ Make sure that position and polarity are correct.
Case 1: KaVo Mini LED lamp is on
Case 2: The KaVo Mini LED lamp is faint
- Increase the cold light intensity on the unit until the desired light intensity is
reached.
Case 3: KaVo Mini LED lamp is red or off
- Insert KaVo Mini LED lamp after rotating it 180° about its axis.
▶ Put the sleeve on while twisting it slightly.
Instructions for use ELECTROmatic M/C and PM/PC
9 Maintenance | 9.2 Replacing the LED lamp of the KL 703 motor
CAUTION
NOTICE
67 / 80