Network Interface - Festo MSE6-E2M Original Instructions Manual

4 Commissioning
LED displays on the bus node CPX-FB36
1
Network-specific LEDs
2
CPX-specific LEDs
Fig. 4.12 LED displays on the bus node CPX-FB36
Network-specific LEDs
MS Module status (red, green)
NS Network status (red, green)
TP1 Link/Traffic 1 (green)
TP2 Link/Traffic 2 (green)
1) In the normal operating status, all green LEDs light up; the yellow and red LEDs do not light up.
2) If there is no network connection, the LED "NS" is off.
3) Parameterisation modified or Force active.
Tab. 4.17 LED displays
4.5.2

Network interface

With bus node CPX-FB36, the connection to the network is effected with the following connection tech­
nology.
Bus node Connection technology
CPX-FB36 2 sockets, M12, D-coded, 4-pin, according
to IEC 61076-2
Tab. 4.18 Overview of connection technology and network plug connectors
• Seal unused connections with cover caps or blanking plugs to achieve the specified
degree of protection.
Festo – MSE6-E2M-SY-EN – 1703d – English
CPX-specific LEDs
PS
2)
PL
ST
M
1
1)
Power system (green)
Power load (green)
System failure (red)
3)
Modify (yellow)
Network connectors
Plug connector NECU-M-S-D12G4-C2-ET
2
41