Festo MSE6-E2M Original Instructions Manual page 118

C Parameters and data
System parameters: Monitor
Function no. 4401
Description The monitoring of short circuit/overload and undervoltage for the MSE6-E2M
can be activated or deactivated (suppressed). Activation of the monitoring func­
tion causes the following. An error registered by the module will be:
– Sent to the higher-order fieldbus master
– Entered, if applicable, in the diagnostic memory (depending on filter settings)
– Entered in the module diagnostic data and, if applicable, in the status bits
– Indicated by the red module common error LED
– Indicated by the red "SF" LED of the bus node.
Monitor
Bit Description
0 Short circuit/overload in sensor supply (SCS)
1 Short circuit/overload at the outputs (SCO)
2 Undervoltage of outputs (U
3 Reserved
4 Short circuit at valves (SCV)
5 ... 7 Reserved
Values 1 = Active (presetting)
0 = Inactive
Comment The mode of operation of the channel error LED remains unaltered. Monitoring
can also be set separately for each module (see module parameter Monitor
è Tab. 7.7).
Tab. C.4 Monitoring short circuit/overload/undervoltage
118
)
OUT
Festo – MSE6-E2M-SY-EN – 1703d – English
[Monitor]
[Monitor SCS]
[Monitor SCO]
[Monitor Vout]
[Monitor SCV]
[Active]
[Inactive]