Procedure - Festo MSE6-E2M Original Instructions Manual

4 Commissioning
4.1

Procedure

In order to avoid connecting and addressing errors, you should carry out the commissioning steps as
follows. The individual commissioning steps are shown in the diagram below.
1
Step 1 – Check the connected pneumatic application
2
Step 2 – Commissioning on bus node with testing of the address allocation
Fig. 4.1 Commissioning steps (example at the bus node CPX-FB33)
Festo – MSE6-E2M-SY-EN – 1703d – English
1
2
17