Festo MSE6-E2M Original Instructions Manual page 105

A General fundamentals on system parameterisation
Parameterisation
With MSE6-E2M, Force parameterisation can be used for:
– Inputs of the I/O diagnostic interface and status bits
– Outputs of the I/O diagnostic interface and status bits
By means of a system parameter, Force is enabled or disabled globally for the MSE6-E2M.
System parameters
Force mode
Tab. A.2 System parameter "Force mode"
The signal status can be defined in a channel-orientated manner (output/input) for each module
(è Tab. A.3).
Module parameter
Force mode
Force state
– Digital signal
– Analogue signal
Tab. A.3 Module parameters "Force mode" and "Force state"
Festo – MSE6-E2M-SY-EN – 1703d – English
Settings
Disabled
(presetting)
Enabled
Settings
Disabled
(presetting)
Force state
Reset signal (presetting)
Set signal
Analogue value
(0 = Presetting)
Description
Force is disabled for the completeMSE6-E2M
Forcing is enabled for the completeMSE6-E2M
Description
Force is blocked for the channel
Accept the signal status defined by Force state
Reset input/output signal
Set input/output signal
Value of the analogue signal
105