Commissioning And Configuration - Festo MSE6-E2M Original Instructions Manual

4 Commissioning
4.4.5

Commissioning and configuration

Commissioning and configuration of the bus node depend on the higher-order control. In the following
section the basic procedure for commissioning is explained.
The following steps are exemplary for the use of the "Siemens SIMATIC S7-315" control
and the "Siemens STEP 7" control software (Version 5.5 with Service Pack SP 3) in Eng­
lish.
Detailed information is provided in the documentation for the higher-order controller and
the control software.
Warning
Uncontrolled movements of the actuators and loose tubing, undefined switching states
of the electronic components
Injury to persons, damage to the machine and system
• Before commissioning, ensure that the connected products do not perform any un­
controlled movements.
• Observe commissioning notices in the documentation of the higher-order control.
No automatic checking of configuration and parameterisation: The bus node and the
connected products are operational even if configuration is incorrect.
Warning
Unexpected behaviour when using PROFIenergy function
In the "Stop" status the outputs are reset when using the PROFIenergy function. With
this, the MSE6-E2M shut-off valve switches to the open state.
Injury caused by moving parts, damage to machine and to system
• Observe the switching characteristics of the MSE6-E2M shut-off valve.
Switch on the power supply
If the control and network participants have separate voltage supplies, the devices must be switched in
the following sequence:
1. Switch on the power supply of the MSE6-E2M.
2. Switch on the power supply for the controller.
Addressing the network
The controller uses the following for addressing:
– device names ("Device Names")
– IP addresses (optional MAC-ID)
– Input and output addresses (I/O addresses).
Festo – MSE6-E2M-SY-EN – 1703d – English 37