Festo MSE6-E2M Original Instructions Manual page 22

4 Commissioning
Connection CPX-FB13with plug connector by Festo
• Note the assembly instructions for the plug connector. Tighten the two mounting screws at first by
hand and then with 0.5 Nm ± 10 %.
With the Festo plug connector (FBS-SUB-9-GS-DP-B), you can connect the MSE6-E2M
easily to the network. The plug can be disconnected from the bus node without interrupt­
ing the bus cable (T-TAP function).
The clamp strap in the plug connector by Festo is connected internally only capacitively
with the metallic housing of the sub-D plug connector. This is to prevent compensating
currents flowing through the screening of the fieldbus line.
1
Folding cover with inspection window
2
Blanking plug if connection unused
3
Clamp strap for screened connection
4
Connection network (IN)
Fig. 4.4 Festo plug connector, FBS-SUB-9-GS-DP-B
22
1 2 3
Bus in
Bus out
OB OB
ON
7 6 5 4
5
Switch for bus terminal and continuing
network (DIL switch)
6
Connection network (OUT)
7
Only capacitively connected
Festo – MSE6-E2M-SY-EN – 1703d – English