Festo MSE6-E2M Original Instructions Manual page 33

4 Commissioning
Network interface on bus node CPX-FB33
There are two 4-pin, D-coded M12 sockets on the bus node CPX-FB33 for the network connection.
Socket, M12 Pin
D-coded
2
1
2
3
1
3
4
Housing
4
Tab. 4.11 Pin allocation of network interfaces on bus node CPX-FB33 (M12)
Connect the bus node to the network with a Festo plug connector (NECU-
M-S-D12G4-C2-ET). The plug connector is designed for Ethernet lines with cable diamet­
ers of 6 ... 8 mm.
Network interface on bus node CPX-M-FB34
There are two RJ45 push-pull socket contacts (AIDA-compliant) on the CPX-M-FB34 for the network
connection.
RJ45 plug socket Pin
Push-pull
1
2
3
4
5
6
7
8
Housing
Tab. 4.12 Pin allocation of network interfaces on bus node CPX-M-FB34 (RJ45)
Connect the bus node to the network with a Festo plug connector (FBS-RJ45-PP-GS). The
plug connector is designed for Ethernet lines with cable diameters of 5 ... 8 mm.
Festo – MSE6-E2M-SY-EN – 1703d – English
Signal Explanation
TD+ Transmission data (transmit data, TD) +
RD+ Receive data (receive data, RD) +
TD– Transmitted data –
RD– Received data –
Shield/FE Shield/functional earth
Signal Explanation
TD+ Transmission data (transmit data, TD) +
TD– Transmitted data –
RD+ Receive data (receive data, RD) +
n.c. Not connected
n.c. Not connected
RD– Received data –
n.c. Not connected
n.c. Not connected
Shield/FE Shield/functional earth
33