Festo MSE6-E2M Original Instructions Manual page 134

C Parameters and data
System data: CPX structure
Function no. 0
Description Specifies whether the current CPX structure corresponds to the saved CPX struc­
ture.
Bit Bit 4
Values CPX structure
Bit 4 Description
0 Equal
1 Unequal
è also "System start" system parameter
Comment
Tab. C.35 CPX structure
System data: Operator unit
Function no. 0
Description Specifies whether or not an operator unit is connected.
Bit Bit 5
Values Operator unit
Bit 5 Description
0 No operator unit is connected
1 Operator unit connected
Comment Information for the higher-order controller.
If necessary for test purposes, a parameterisation carried out using an operator
unit is to be cancelled by reloading the parameters, or forcing by higher-order
PLC/IPC is to be blocked whilst an operator unit is connected.
Tab. C.36 Operator unit
System data: Force mode
Function no. 0
Description Specifies whether Force is disabled or enabled.
Bit Bit 6
Values Force mode
Bit 6 Description
0 Disabled
1 Enabled
è also "Force mode" system parameter
Comment
Tab. C.37 Force mode
134
[CPX structure]
[equal]
[unequal]
[Handheld]
–
[connection OK]
[Force mode]
[Disabled]
[Enabled]
Festo – MSE6-E2M-SY-EN – 1703d – English