Using The Memory Card; Network Interface - Festo MSE6-E2M Original Instructions Manual

4 Commissioning
4.4.2

Using the memory card

The memory card is used as a carrier of configuration data for PROFINET addressing and thus simplifies
bus node replacement:
– PROFINET I/O device name
– IP address.
Note
Inserting or removing the memory card while the power supply is switched on can result
in malfunctions of or damage to the memory card.
• Disconnect the power supply before you insert or remove the memory card.
Data stored on the card has priority over other configuration data which is stored, e.g. in
the bus node memory or in the higher-order controller.
1. Switch off power supply.
2. Unscrew and remove the fastening screws of the cover
3. Remove cover.
4. Insert memory card.
5. Fit cover.
6. Tighten mounting screws of the cover at first by hand and then with 0.4 Nm ± 10 %.
4.4.3

Network interface

Depending on the bus node, the connection to the network is effected with a specific connection tech­
nology.
Bus node Connection technology
CPX-FB33 2 sockets, M12, D-coded, 4-pin, according
to IEC 61076-2
CPX-M-FB34 2 RJ45 sockets, push-pull, AIDA-compli­
ant, corresponding to IEC 60603,
IEC 61076-3
CPX-M-FB35 2 SCRJ sockets, push-pull, AIDA-compli­
ant, corresponding to IEC 61754-24,
650 nm wavelength, suitable for POF
fibre-optic cable
Tab. 4.10 Overview of connection technology and network plug connectors
• Seal unused connections with cover caps or blanking plugs to achieve the specified
degree of protection.
32
.
Network connectors
Plug connector NECU-M-S-D12G4-C2-ET
Plug connector FBS-RJ45-PP-GS
Plug connector FBS-SCRJ-PP-GS
Festo – MSE6-E2M-SY-EN – 1703d – English