Festo MSE6-E2M Original Instructions Manual page 79

7 Parameterisation
Module parameter: Upper limit flow
Function no. 4828 + m * 64 + 11 (Low Byte)
4828 + m * 64 + 12 (High Byte)
Description An upper flow limit can be set for the module.
Values 2-byte value: Low Byte + 256 * High Byte
Presetting:
Permitted values:
Memo If parameterisation error monitoring is active (P0.7), invalid values will lead to the
parameterisation error FN25 è Tab. 8.19.
If the flow set according to the parameterisation (unit) exceeds the parameterised
upper limit, the diagnostic message FN10 is output if the parameter "Monitoring
limits" is active.
The monitoring of limit value violation only becomes active after the expiry of the
time parameterised in the parameter "Monitor limit values startup". The time is
active even after shifting to the state "pressurisation".
Tab. 7.14 Upper limit flow
Module parameter: Upper limit pressure
Function no. 4828 + m * 64 + 13 (Low Byte)
4828 + m * 64 + 14 (High Byte)
Description An upper pressure limit can be set for the module.
Values 2-byte value: Low Byte + 256 * High Byte
Presetting:
Permitted values:
Memo If parameterisation error monitoring is active (P0.7), invalid values will lead to the
parameterisation error FN25 è Tab. 8.19.
If the pressure P2 according to the parameterisation (unit) exceeds the paramet­
erised upper limit, the diagnostic message FN10 is output if the parameter "Monit­
oring limits" is active.
The monitoring of limit value violation only becomes active after the expiry of the
time parameterised in the parameter "Monitor limit values startup".
Tab. 7.15 Upper limit pressure
Festo – MSE6-E2M-SY-EN – 1703d – English
32767 (Low Byte = 255; High Byte = 127)
0 ... 32767
32767 (Low Byte = 255; High Byte = 127)
0 ... 32767
[Upper limit flow
m = module number (1)
[Upper limit pressure
m = module number (1)
79
]
]