Festo MSE6-E2M Original Instructions Manual page 45

4 Commissioning
Setting the diagnostic mode (DIL switch 2)
Setting of DIL switch 2
DIL 2.1: OFF
DIL 2.2: OFF
(factory setting)
DIL 2.1: OFF
DIL 2.2: ON
DIL 2.1: ON
DIL 2.2: OFF
DIL 2.1: ON
DIL 2.2: ON
1) Status bits occupy 1 byte of address space (8 I bits)
2) I/O diagnostics interface occupies 4 bytes of address space (16 I and 16 O bits)
Tab. 4.23 Set diagnostic mode using DIL switch 2
Festo – MSE6-E2M-SY-EN – 1703d – English
Setting the diagnostic mode
(in remote I/O operating mode)
The I/O diagnostic interface and status bits are switched off
(+ 0 byte I/0 Byte O)
Status bits are switched on
1)
(+ 1 byte I/0 byte O)
I/O diagnostics interface is switched on
2)
(+ 2 bytes I/2 bytes O)
Reserved for future extensions
45