Festo MSE6-E2M Original Instructions Manual page 76

7 Parameterisation
"Units" module parameter
The parameter specifies in which unit flow, air consumption, module output pressure P2 and the stand­
ard conditions for the flow measurement of the MSE6-E2M are transmitted to the higher-order control­
ler. In addition, the standard conditions for the measurement of the flow are specified.
The data width is 8 bits (1 byte).
In the "Units" module parameter, the parameters "Unit Pressure", "Unit Flow", "Unit Consumption" and
"Unit Flow standard" each occupy 2 bits.
Module parameter: Unit Pressure
Function no. 4828 + m * 64 + 8
Description Specifies the unit for all pressure-related input values and parameters.
Bit Bit 0, 1:
All other bits are reserved.
Values
Bit 1 0 Value
0 0 0
0 1 1
1 0 2
1 1 3
Memo If parameterisation error monitoring is active (P0.7), invalid values will lead to
the parameterisation error FN29 è Tab. 8.19
Tab. 7.9 Unit Pressure
Module parameter: Unit Flow
Function no. 4828 + m * 64 + 8
Description Specifies the unit for all flow-related input values and parameters.
Bit Bit 2, 3:
All other bits are reserved.
Values
Bit 3 2 Value
0 0 0
0 1 1
1 0 2
1 1 3
Memo If parameterisation error monitoring is active (P0.7), invalid values will lead to
the parameterisation error FN29 è Tab. 8.19
Tab. 7.10 Unit Flow
76
Unit Pressure
Significance
mbar (presetting)
kPa
psi/10
Not permissible
Unit Flow
Significance
l/min (presetting)
Not permissible
scfm/10
Not permissible
m = module number (1)
m = module number (1)
Festo – MSE6-E2M-SY-EN – 1703d – English
[Unit Pressure]
[Unit Flow]