Parameterisation; Parameterisation Options - Festo MSE6-E2M Original Instructions Manual

7

Parameterisation

7
Parameterisation
7.1

Parameterisation options

Depending on the network protocol used, parameterisation of the MSE6-E2M can be performed as
follows:
1
1
Interface module or network scanner/bus
master; the desired parameterisation can be
ensured e.g. in the start-up phase or after
network interruptions.
2
User program in the higher-order controller;
parameters can be modified during opera­
tion.
Fig. 7.1 Options for parameterisation (as an example on the bus node CPX-FB33)
70
2 3
3
Network-specific configurators; parameters
can be modified during the commissioning
phase or during troubleshooting.
4
Operator unit; parameters can be modified
during commissioning or during
troubleshooting.
Festo – MSE6-E2M-SY-EN – 1703d – English
4