Festo MSE6-E2M Original Instructions Manual page 46

4 Commissioning
Setting the IP addressing (DIL switch 3)
The type of addressing or the IP address of the MSE6-E2Mis set via DIL switches 3.1 ... 3.8.
Setting of DIL switch 3
DIL 3.1 ... 3.8: OFF
DIL 3.8: OFF
DIL 3.7: ON
DIL 3.6: OFF
DIL 3.5: ON
DIL 3.4: OFF
DIL 3.3: ON
DIL 3.2: ON
DIL 3.1: OFF
DIL 3.1 ... 3.8: ON
Tab. 4.24 Set the IP addressing (DIL switch 3)
46
Setting IP addressing
Dynamic/saved addressing
All DIL switches in the OFF position (factory setting).
When the MSE6-E2Mis switched on, it receives a
dynamic or saved IP address via DHCP/BOOTP.
7
2 = 128 Fixed addressing
6
2 = 64 The host ID of the IP address (4th octet) is set binary
5
coded using DIL switches 3.1 ... 3.8.
2 = 32
4
Permissible range of values: 1 ... 254
2 = 16
3
2 = 8
2
Example:
2 = 4
1 2
1
2 + 2 + 2
2 = 2
0 Set IP address: 192.168.1.86
2 = 1
Resetting all IP parameters to factory settings
All DIL switches in ON position.
All IP parameters of the MSE6-E2M are reset to the
factory settings when device is switched on.
4 6
+ 2 = 2 + 4 + 16 + 64 = 86 (host ID)
Festo – MSE6-E2M-SY-EN – 1703d – English