Commissioning And Configuration - Festo MSE6-E2M Original Instructions Manual

4 Commissioning
4.5.4

Commissioning and configuration

Commissioning and configuration of the bus node depend on the higher-order control. In the following
section the basic procedure for commissioning and configuration with the Festo Maintenance Tool
(CPX-FMT) is explained.
The following steps provide an example for the use of a controller by Ellen-Bradley and
the "Rockwell Studio 5000" controller software (Version 24) and the Festo Maintenance
Tool (CPX-FMT) software in English.
Detailed information is provided in the documentation for the higher-order controller and
the control software.
Warning
Uncontrolled movements of the actuators and loose tubing, undefined switching states
of the electronic components
Injury to persons, damage to the machine and system
• Before commissioning, ensure that the connected products do not perform any un­
controlled movements.
• Observe commissioning notices in the documentation of the higher-order control.
No automatic checking of configuration and parameterisation: The bus node and the
connected products are operational even if configuration is incorrect.
Switch on the power supply
If the control and network participants have separate voltage supplies, the devices must be switched in
the following sequence:
1. Switch on the power supply of the MSE6-E2M.
2. Switch on the power supply for the controller.
Addressing the network
The controller uses the following for addressing:
– IP addresses
– Input and output addresses (I/O addresses).
Basic addressing rules
Bus nodes:
– The bus node occupies 0 inputs and 0 outputs if the diagnostic mode is not active.
– Active status bits occupy 8 input bits.
– An active I/O diagnostic interface occupies 16 input and 16 output bits.
Network:
– The address assignment of the inputs is independent of the address assignment of the outputs.
– Addressing is carried out in bytes.
Festo – MSE6-E2M-SY-EN – 1703d – English 47