Using The Memory Card - Festo MSE6-E2M Operating Instruction

Commissioning
LED displays on the bus node CPX-M-FB43 and CPX-M-FB44
Fig. 27: LED display on the bus node CPX-M-FB43
and CPX-M-FB44
Network-specific LEDs
NF Network failure, red
M/P Maintenance/PROFlenergy, green
TP1 Link 1, green
TP2 Link 2, green
1) If there is no network connection, the NF LED flashes.
2) In the standard operating status all green LEDs are on. The yellow and red LEDs are not on.
3) Parameterisation modified or force active.
Tab. 35: LED displays
8.6.2

Using the memory card

The memory card is used as a carrier of configuration data for PROFINET addressing and thus simpli-
fies bus node replacement:
– PROFINET I/O device name
– IP address
NOTICE
Malfunction or Damage to the Memory Card.
Inserting or removing the memory card while the power supply is switched on can result in malfunc-
tions of or damage to the memory card.
• Disconnect the power supply before you insert or remove the memory card.
Data stored on the memory card has priority over other configuration data which is stored, e.g. in the
bus node memory or in the higher-order controller.
1. Switch off the power supply.
2. Unscrew the retaining screws of the cover.
3. Remove the cover.
4. Insert the memory card.
Festo — MSE6-E2M — 2022-08d
1 2
1)
1
Network-specific LEDs
2
CPX-specific LEDs
2)
CPX-specific LEDs
PS Power system, green
PL For MSE6-E2M without function.
SF System failure, red
3)
M Modify, yellow
51