GRAPHTEC midi LOGGER GL240 User Manual page 79

Illuminance / Ultraviolet Sensor of the wireless sensor setting: optional
(GL100-WL+GS-LXUV)
Perform the settings for the illumination / ultraviolet sensor input of wireless sensors.
When the wireless sensor and illumination / ultraviolet sensor are connected, the setting screen is displayed.
(1)-34 Input setting
This is used to select the input conditions.
Setting
Off
1ch ILLUM.
2ch UV
3ch ACC. ILLUM. Used to measure the accumulated illuminance.
4ch ACC. UV.
5ch to 8ch No AMP
(1)-35 Range setting
This is used to select the illuminance range to be measured. The ultraviolet and accumulated ultraviolet ranges
are fixed.
Setting
ILLUM.
UV
ACC. ILLUM.
ACC. UV.
Do not change the range through the GL100-WL after setting the range of the GL240.
The displayed values of the GL240 may not match the measured values.
The input signal is not measured. The waveform and digital display also are not performed.
Used to measure the illuminance
Used to measure the ultraviolet.
Used to measure the accumulated ultraviolet.
When connecting the two GS series and terminal / addapter using a branch adapter for GS, the
following combination is displayed.
Combination CH1 to 4
TH+LXUV TH
TH+CO2 TH
LXUV+CO2 LXUV
Symbols in the table are as follows:
TH: Temperature and humidity sensor
LXUV: Illumination / ultraviolet sensor
CO2: CO2 sensor
2000, 20000lx, 200klx (operates in conjunction with 3ch)
30mW/cm fixed range
2
2000, 20000lx, 200klx (operates in conjunction with 1ch)
30mW/cm fixed range
2
CHAPTER 3 Settings and Measurement
Description
CH5 to 8
LXUV
CO2
CO2
Description
3-37