GRAPHTEC midi LOGGER GL240 User Manual page 76

CHAPTER 3 Settings and Measurement
4ch Voltage / Temperature Terminal of the wireless sensor setting: optional
(GL100-WL+GS-4VT)
Perform the settings for the 4ch voltage / temperature terminal input of wireless sensors.
When the wireless sensor and 4ch voltage / temperature terminal are connected, the setting screen is
displayed.
(1)-22 Input setting
This is used to select the input conditions.
Setting
1ch to 4ch Off
DC
TEMP
5ch to 8ch No AMP
(1)-23 Sensor setting
This is used to select the sensor type to be used.
Setting
TC-K
TC-T
(1)-24 Range setting
Setting
DC
TEMP
Do not change the range through the GL100-WL after setting the range of the GL240.
The displayed values of the GL240 may not match the measured values.
(1)-25 EU setting
This is used to unit-convert the measurement signal.
Refer to "EU Function, Meas. Value, EU Output Value, and Reads the current temperature measurement
value" in "(1)-5 EU (Scaling settings)" in "3.4 Setting Menus". In the case of Voltage, refer to "<Setting
example: For voltage input>".
3-34
The input signal is not measured. The waveform and digital display also are not performed.
Used to measure the direct-current voltage.
Used to measure the temperature.
Because the other wireless sensor cannot be installed, the "No AMP" is displayed..
Set when the thermocouple to be connected is K-type.
Set when the thermocouple to be connected is T-type
20, 50, 100, 200, 500mV; 1, 2, 5, 10, 20, 50V; 1-5V
2000°C fixed range
Description
Description
Description