Setting Menus - GRAPHTEC midi LOGGER GL240 User Manual

3.4 Setting Menus

When you press the [MENU] key during Free Running, the following menu screens appear.
<When optional wireless unit is installed>
AMP
<When optional wireless unit is not installed>
AMP
(1) AMP settings
This menu is used to specify input signal-related settings.
<Analog settings>
The GL100-WL+GS sensor shown below is required to install the optional wireless unit.
For more information about the GL240 and GL100-WL wireless connection, refer to "(5) LAN setting" and
the operation procedure example in "3.4 Setting Menus".
Input
Temperature and
humidity sensor
(GL100-WL+GS-
TH)
3-axis acceleration
/ temperature
sensor (GL100-
WL+GS-3AT)
4ch voltage /
temperature
terminal (GL100-
WL+GS-4VT)
4ch thermistor
(GL100-WL+GS-
4TSR)
DAT
DATA
Setting
Range [Voltage]
[Temperature] Sensor
[Humidity]
Filter
Range [Temperature] / [Dew-point
temperature] / [Accumulated
temperature]
[Humidity]
Filter
Range [Acceleration] Sensor
[Humidity]
Filter
Range [Voltage]
[Humidity]
Filter
Range [Humidity]
Filter
TRG I/F
TRIG I/F
<Logic Pulse settings>
20, 50, 100, 200, 500mV; 1, 2, 5, 10, 20, 50, 100V; 1-5V
Thermocouple: TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S, TC-N,
TC-W
Range 2000°C fixed
100% fixed
Off, 2, 5, 10, 20, 40
100°C fixed
100% fixed
None
Peak / Ave. / RMS
Range 2, 5, 10G; 20, 50, 100m/s
100% fixed
None
20, 50, 100, 200, 500mV; 1, 2, 5, 10, 20, 50V; 1-5V
Sensor Thermocouple: TC-K , TC-T
Range 2000°C fixed
None
Sensor Thermistor: TSR-A, TSR-J
Range 200°C fixed
None
CHAPTER 3 Settings and Measurement
LAN OTH
OTHR
Selections available
2
3-19