GRAPHTEC midi LOGGER GL240 User Manual page 73

Temperature and humidity sensor of the wireless sensor setting: optional
(GL100-WL+GS-TH)
Perform the settings for the temperature and humidity sensor input of wireless sensors.
When the wireless sensor and temperature and humidity sensors are connected, the setting screen is
displayed.
(1)-13 Input settings
Setting
Off
1ch TEMP
2ch RH
3ch DEW
4ch ACC. TEMP
5ch to 8ch No AMP
(1)-14 Range settings
This is used to select the voltage range to be measured. The temperature range is fixed.
Setting
TEMP
RH
(1)-15 EU setting
The offset of temperature/dew point temperature only can be adjusted.
Refer to "EU Function, Meas. Value, EU Output Value, and Reads the current temperature measurement
value" in "(1)-5 EU (Scaling settings)" in "3.4 Setting Menus".
Even if the scaling setting is applied to the original measured value of CH, the accumulated temperature is
not reflected in the accumulated temperature CH.
The input signal is not measured. The waveform and digital display also are not performed.
Used to measure the temperature
Used to measure the humidity.
Used to measure the dew-point temperature.
Used to measure the accumulated temperature.
When connecting the two GS series and terminal / addapter using a branch adapter for GS, the
following combination is displayed.
Combination CH1 to 4
TH+LXUV TH
TH+CO2 TH
LXUV+CO2 LXUV
Symbols in the table are as follows:
TH: Temperature and humidity sensor
LXUV: Illumination / ultraviolet sensor
CO2: CO2 sensor
100℃ fixed range
100% fixed range
CHAPTER 3 Settings and Measurement
Description
CH5 to 8
LXUV
CO2
CO2
Description
3-31