GRAPHTEC midi LOGGER GL240 User Manual page 103

(5) Set the wireless standard 11n.
When the IEEE802.11n is used, set to "ON".
Select the "Reflection of setting" with the
The "Wireless LAN restarting" message is displayed and the main unit is re-started to reflect the settings.
(5)-5 Other setting
Perform the wireless LAN setting in the other setting.
<Example 1 of operation procedure>
(1) Set to Access point and then restart the wireless LAN. The GL240 is switched to Access point setting
mode.
When the restart is complete, the following MENU display is displayed.
(2) Set the necessary conditions up to the setting.
Access point setting: Set the necessary settings and press the "Apply settings" (
(3) Set the AP-IP in the Other setting and then set the wireless sensor.
When the wireless sensor is not enabled, the wireless sensor setting cannot be performed.
Make sure that the connected wireless sensor is in the wireless LAN status.
Select the wireless sensor setting to open the sub screen
Connection
Device name
• Switch the connection to [On].
• Enter the device name manually, or search the device name.
• When performing the search: Select the wireless sensor to be connected. Then, the device name is
entered automatically.
• The information of the GS sensor and terminal/addapter recognized by the GL240 main unit is displayed
in the AMP1 and AMP2. Even if you change the connection or device name, it is not changed. After
confirming the settings, it will be changed when the wireless sensor is newly recognized after power
cycle.
• The settings are saved by pressing the [OK]. (However, because it is not reflected in the operation at
this time, please be sure to run power cycle.)
key when the above settings are finished.
Search
Device access display
When connecting the child unit to the wireless LAN, the radio
wave strength of the base unit is displayed. When connecting the
child unit to the base unit, the number of the child units (wireless
sensor) connected to this GL240 main unit is displayed.
Wireless sensor display
This is displayed when the GL100-WL (connected
to GS sensor and terminal/addapter) is connected
through the wireless connection.
CHAPTER 3 Settings and Measurement
key).
3-61