GRAPHTEC midi LOGGER GL240 User Manual page 68

CHAPTER 3 Settings and Measurement
(1)-6 Misc.
The information varies depending on GL240 amplifier and GS sensor or terminal/adapter (settable when it is
connected through the wireless sensor).
* Please check the setting target and the information of the item number in the table below.
Setting object
Voltage, (1) Annotation Settings
humidity,
(2) Inter-CH Op Settings
acceleration
settings
(3) Span Settings
(4) Waveform Color Setting
(5) Line Thickness Setting
(6) Trace
(7) Perform Auto Zero ADJ.
(8) Reset Auto Zero ADJ.
(9) Set Zero Point as:
When GS sensor and terminal/addapter are used
* For the number in the setting items in the following table, refer to the voltage, humidity and acceleration
settings described above.
Setting object
Temperature
setting
Logic setting
Pulse setting
CO2 setting
AC clamp setting
3-26
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Setting
(Auto balance in the case of
acceleration)
Setting
(1), (2), (3), (4), (5), (6)
Accumulated reference
temperature
Accumulated polarity
(5), (6)
(4), (5), (6)
Number of pulses per revolution
(1), (2), (3), (4), (5), (6)
CO2 calibration
(1), (2), (3), (4), (5), (6)
Voltage (Power only)
Power factor (Power only)
Auto zero adjustment
Zero adjustment reset
Set the annotation (comment) displayed in the CH.
Set what to do in calculation between channels.
Four arithmetic operations (+, -, x, ÷) can be set as calculation between
channels.
Set the upper and lower limits of values of a span in which a waveform
should be displayed.
0 to 31 for each of red, green, blue (RGB)
Setting 1 to 8 dots
This is used to set the waveform display.
The current input voltage (acceleration value) is calculated as a zero
point voltage value (acceleration value).
Automatic adjustable voltage range is within ±10% of set range.
Reset the zero point voltage value (acceleration value).
* When the temperature is set, this function is not available.
The zero point voltage value (acceleration value) is displayed.
* When the temperature is set, this function is not available.
Same content as the voltage.
Set the reference temperature accumulated within the range of -20 to
+85°C for the temperature and humidity sensor.
Set High/Low accumulated polarity.
Same content as the voltage.
Same content as the voltage.
Set the number of pulses per revolution.
Same content as the voltage.
Set the CO2 calibration.
Same content as the voltage.
Set the measurement voltage value to calculate the power within the
range of 90 to 264V.
Set the power factor to calculate the power within the range of 0.30 to 1.00.
Display the input voltage after releasing the zero point voltage value.
Display the zero point voltage value. (Display only)
Description
Description