Setting Menus - GRAPHTEC GL900 User Manual

3.4

Setting Menus

When you press the MENU key during Free Running, the following menu screens appear.
The menu screens are classified by the tab for each setting item.
AMP
(1) AMP settings
This menu is used to specify input signal-related settings.
<Analog settings>
Input
Range [Voltage]
[Temperature]
Filter
EU Function
(Scaling Measured Upper limit value
settings) value
EU output Upper limit value
value
Decimal point
Unit selection
Unit
User-defined unitText input
Misc. Span
setting
Annotation setting
Perform Auto Zero ADJ.
Reset Auto Zero ADJ.
Logic and Pulse
[Logic]
[Pulse]
[xxx] shows a case in which xxx is selected from available selections.
DATA TRIG
Setting
Lower limit value
Lower limit value
Upper limit value
Lower limit value
Input
Filter
Slope
EU Function
Measured value Numeric value input
EU output value Numeric value input
Unit selection
Unit
User-defined unit Text input
OPT OTHR
<Logic and Pulse settings>
Selections available
Off, Voltage, Temperature, Humidity
20, 50, 100, 200, 500 mV; 1, 2, 5, 10, 2
TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S
Line, A5, 50, 500Hz
Off, On
Numeric value input
Numeric value input
Numeric value input
Numeric value input
1, 10, 100, 1000, 10000
Current, length, area, volume, speed, acceleration, frequency,
weight, power, pressure, flow, temperature
(Selections vary depending on the selected units listed in the above.)
Numeric value input
Numeric value input
Text input (11 characters max.)
Execute
Execute
Off, Logic, Pulse
Off, On
Off, Revolution counts, Counts, Inst.
Off, On
↑ H, ↓ L
Off, On
Current, length, area, volume, speed, acceleration, frequency,
weight, power, pressure, flow, temperature
(Selections vary depending on the selected units listed in the above.)
Settings and Measurement
3-17