Satec Expertmeter EM720 Operation Manual page 142

Chapter 8 Retrieving Recorded Data
Suspending the Scheduler
142
5. Select a daily, weekly or monthly schedule, and
adjust the start time. If you wish to upload data
periodically in predefined intervals, click on
"Periodic" and define the time period in hours and
minutes.
6. Select the number of attempts to upload data in the
event of temporary communication problems or
unavailability of your device, and the delay between
attempts in minutes and seconds.
7. If you wish to use the schedule to synchronize the
device clock with your PC, check the "RTC
Synchronization Enable" box. If your device is
password protected by a communications password,
type in the password you set in the device to allow
PAS to update the clock.
8. Click on the Select Logs button, check the boxes for
logs you want to upload on a schedule, and then
click OK.
9. Check the Enabled box at left to activate a schedule
for the device.
10. Click OK to store your schedule.
To keep the Upload Scheduler running, the On-line button
on the PAS toolbar must be checked all the time. If
you uncheck it, the scheduler stops operations. This does
not cause loss of data, since the scheduler will resume
operations when you check this button again.
To suspend the Upload Scheduler, check the Suspend
Scheduler box at right. To activate the Upload Scheduler,
leave this box unchecked.
EM720 Power Quality and Revenue Meter
Using the Upload Scheduler