Setting Parameters On Communications Setting Level - Omron K7DD User Manual

6 Using K7DD Parameters
6-7-2

Setting Parameters on Communications Setting Level

bps1/bps2
Set the baud rate of the communications
terminal 1 or 2.
pty1/pty2
Set the parity of the communications terminal 1
or 2.
When the set value is changed from "Even" or
"Odd" to "None," the internal stop bit is changed
from 1 bit to 2 bits. Similarly, if the set value is
changed from "None" to "Even" or "Odd," the
internal stop bit is changed from 2 bits to 1 bit.
swt1/swt2
Set the send wait time of the communications
terminal 1 or 2.
This is a wait time from when the K7DD receives
a command from the host system until it returns
a response. If the response comes so fast that
the host system cannot receive it properly,
increase this setting value. If you want to make
the communications response time faster,
decrease this setting value.
6 - 24
Baud Rate 1/Baud Rate 2
Setting-related page
Initial Setting of Communications Converter (P.3-14) of 3-6 Wiring
the Communications Cables
Parity 1/Parity 2
Setting-related page
Initial Setting of Communications Converter (P.3-14) of 3-6 Wiring
the Communications Cables
Send Wait Time 1/Send Wait Time 2
Range of setting values
9.6 (kbps)
19.2 (kbps)
38.4 (kbps)
57.6 (kbps)
115.2 (kbps)
230.4 (kbps)
Range of setting values
none: None
even: Even
Odd
odd:
Range of setting values
0 to 99 (ms)
Power Line Data Generator User's Manual (N233)
Default
value
115.2
Default
value
even
Default
value
20 (ms)