Saving An Instrument State - Agilent Technologies 8753ET User Manual

Saving an Instrument State

1. Press
Save/Recall
SEL QUAD
INTERNAL DISK
EXTERNAL DISK
and configure as follows:
a. Connect an external disk drive to the analyzer's GPIB connector, and configure as
follows:
b. Press
Local
located, followed by
c. If your storage disk is partitioned, press
volume number where you want to store the instrument state file.
d. Press
SET ADDRESSES
e. Enter the GPIB address of the peripheral, if the default address is incorrect
(default = 00). Follow the entry by pressing
f. Press
Local
—
SYSTEM CONTROLLER
—
TALKER/LISTENER
peripheral access operations.
—
USE PASS CONTROL
allows the analyzer to take or pass control.
2. Press
Save/Recall
The analyzer saves the state in the next available register, if you are saving to internal
memory, or saves the state to disk. Although one file is shown to represent an
instrument state on the analyzer display, each instrument state is composed of
numerous files (which can be viewed on a PC).
NOTE If you have saved enough files that you have used all the default names
(FILE00 − FILE31 for disk files, or REG1 − REG31 for memory files), you
must do one of the following to save more states:
• use another disk
• rename an existing file to make a default name available
• re-save a file/register
• delete an existing file/register
and select one of the storage devices:
DEFINE PLOT
connect an external disk drive to the analyzer's GPIB connector,
DISK UNIT NUMBER
.
x1
ADDRESS: DISK
and select one of the following:
allows the analyzer to control peripherals directly.
allows the computer controller to be involved in all
allows you to control the analyzer over GPIB and also
.
SAVE STATE
Printing, Plotting, and Saving Measurement Results
and enter the drive where your disk is
VOLUME NUMBER
.
.
x1
Saving an Instrument State
and enter the
4-41