Agilent Technologies 8753ET User Manual page 138

Figure 2-13 Diagram of Measurement Frequencies
Figure 2-14 Measurement Setup from Display
17.To view the measurement trace, press:
VIEW MEASURE
18.To perform a one-sweep power meter calibration of the analyzer's source output power
over the RF frequency range, press:
PWRMTR CAL
Cal
NOTE Do not reduce the number of points to perform this power meter calibration.
Reducing the number of points will turn off the receiver calibration.
The analyzer is now displaying the conversion loss of the mixer calibrated with power
meter accuracy.
19.To view the conversion loss in the best vertical resolution, press:
AUTOSCALE
Scale Ref
ONE SWEEP
0 x1
Making Mixer Measurements
Conversion Loss Using the Frequency Offset Mode
TAKE CAL SWEEP
2-17