Agilent Technologies 8753ET User Manual page 35

Making Measurements
Using Display Functions
CH2 DATA/LIMIT LN
CH2 MEM
GRATICULE
TEXT
To change the color of a display elements, press the softkey for that element (such as
). Then press
CH1 DATA
or the numeric keypad, until the desired color appears.
Maximum viewing with the LCD display is achieved when primary colors or a
NOTE
combination of them are selected at full brightness (100%).
recommended colors and their corresponding tint numbers.
Table 1-2 Display Colors with Maximum Viewing Angle
Display Color Tint
Red 0
Yellow 17
Green 33
Cyan 50
Blue 67
Magenta 83
White N/A
Color is comprised of three parameters:
• Tint: The continuum of hues on the color wheel, ranging from red, through green and
blue, and back to red.
• Brightness: A measure of the brightness of the color.
• Color: The degree of whiteness of the color. A scale from white to pure color.
The most frequently occurring color deficiency is the inability to distinguish red, yellow,
and green from one another. Confusion between these colors can usually be eliminated by
increasing the brightness between the colors. To accomplish this, press the
softkey and turn the analyzer front panel knob. If additional adjustment
BRIGHTNESS
is needed, vary the degree of whiteness of the color. To accomplish this, press the
softkey and turn the analyzer front panel knob.
1-22
CH4 DATA/LIMIT LN
CH4 MEM
REF LINE
WARNING
and turn the analyzer front panel knob; use the step keys
TINT
Brightness
100
100
100
100
100
100
100
Color
100
100
100
100
100
100
0
Table 1-2 lists the
COLOR