Storing A Sequence On A Disk; Loading A Sequence From Disk; Purging A Sequence From Disk - Agilent Technologies 8753ET User Manual

Making Measurements
Using Test Sequencing

Storing a Sequence on a Disk

1. To format a disk, refer to
Results."
2. To save a sequence to the internal disk, press:
MORE STORE SEQ TO DISK
Seq
The disk drive access light should turn on briefly. When it goes out, the sequence has
been saved.
The analyzer will overwrite a file on the disk that has the same title.
CAUTION
CAUTION Do not mistake the line switch for the disk eject button.

Loading a Sequence from Disk

For this procedure to work, the desired file must exist on the disk in the analyzer drive.
1. To view the first six sequences on the disk, press:
MORE LOAD SEQ FROM DISK
Seq
• If the desired sequence is not among the first six files, press:
READ SEQ FILE TITLS
2. Press the softkey next to the title of the desired sequence. The disk access light should
illuminate briefly.
NOTE If you know the title of the desired sequence, you can title the sequence (1–6)
with the name, and load the sequence. This is also how you can control the
sequence number of an imported titled sequence.

Purging a Sequence from Disk

1. To view the contents of the disk (six titles at a time), press:
MORE STORE SEQ TO DISK
Seq
READ SEQ FILE TITLS
• If the desired sequence is not among the first six files, press:
READ SEQ FILE TITLS
2. Press the softkey next to the title of the desired sequence. The disk access light should
illuminate briefly.
1-90
Chapter 4 , "Printing, Plotting, and Saving Measurement
and select the particular sequence softkey.
READ SEQ FILE TITLS
until the desired file name appears.
PURGE SEQUENCES
until the desired file name appears.