Customizing The Four-Channel Display - Agilent Technologies 8753ET User Manual

9. To independently control the channel markers:
Press
Marker Fctn
Rotate the front panel control knob. Marker 2 moves only on the channel 3 trace.
Once made active, a channel can be configured independently of the other channels in most
variables except stimulus. For example, once channel 3 is active, you can change its format
to a Smith chart by pressing

Customizing the Four-Channel Display

When one or both auxiliary channels are enabled,
SPLIT DISP 1X 2X 4X
Table 1-1
Table 1-1 Customizing the Display
Split Display Dual Channel
1X Don't Care
1X/2X/4X Off
2X/4X Off
2X On
4X On
4X On
Channel Position Softkey
CHANNEL POSITION
,
Display DUAL|QUAD SETUP
CHANNEL POSITION
selected,
CHANNEL POSITION
• Channels 1 and 2 overlaid in the top graticule, and channels 3 and 4 are overlaid in the
bottom graticule.
• Channels 1 and 3 are overlaid in the top graticule, and channels 2 and 4 are overlaid in
the bottom graticule.
When
SPLIT DISP 4X
four-graticule display:
• Channels 1 and 2 are in separate graticules in the upper half of the display, channels 3
and 4 are in separate graticules in the lower half of the display.
• Channels 1 and 3 are in the upper half of the display, channels 2 and 4 are in the lower
half of the display.
MARKER MODE MENU
SMITH CHART
Format
interact to produce different display configurations according to
Aux Channels On
Don't Care
None
3 or 4
Don't Care
3 or 4
Both on
gives you options for arranging the display of the channels. Press
to use
CHANNEL POSITION
works with
SPLIT DISP 1X 2X 4X
gives you two choices for a two-graticule display:
is selected,
CHANNEL POSITION
, set to UNCOUPLED.
MARKERS:
.
DUAL CHAN on OFF
Number of Graticules
1
2
3
4
.
. When
SPLIT DISP 2X
gives you two choices for a
Making Measurements
Using Display Functions
and
is
1-17