Agilent Technologies 8753ET User Manual page 98

Figure 1-66 Test Sequencing Help Instructions
2. To select a sequence position in which to store your sequence, press:
SEQUENCE 1 SEQ1
This choice selects sequence position #1. The default title is SEQ1 for this sequence.
Refer to "Changing the Sequence Title" on page 1-89
sequence title.
3. To create a test sequence, enter the parameters for the measurement that you wish to
make. For this example, a SAW filter measurement is set up with the following
parameters:
Save/Recall SELECT DISK
Use the front panel knob to scroll until Preset State is highlighted on the display.
RETURN RECALL STATE
Meas Trans: FWD S21 (B/R)
LOG MAG
Format
Center 134
Span 50 M/µ
Scale Ref AUTOSCALE
INTERNAL MEMORY
or
TRANSMISSION
M/µ
Making Measurements
Using Test Sequencing
for information on how to modify a
1-85