Agilent Technologies 8753ET User Manual page 168

4. To select a ratio B/R measurement, press:
INPUT PORTS
Meas
NOTE Isolation is dependent on LO power level and frequency. To ensure good test
results, you should choose these parameters as close to actual operating
conditions as possible.
5. Make the connections as shown in
Figure 2-36 Connections for a Response Calibration
6. Perform a response calibration by pressing
.
THRU
7. Make the connections as shown in
Figure 2-37 Connections for a Mixer RF Feedthrough Measurement
B/R
Figure 2-36.
Cal
Figure 2-37.
Making Mixer Measurements
Isolation Example Measurements
CALIBRATE MENU RESPONSE
2-47