Agilent Technologies 8753ET User Manual page 324

5. Perform the 2-port error correction using calibration standards appropriate for the
connector type at port 2 (the connector type for adapter A2).
6. Save the results to disk. Name the file "PORT2."
7. Determine the electrical delay of adapter A3 by performing steps 1 through 7 of
the Cal Kit Thru Definition" on page
Remove the Adapter
When the two sets of error correction files have been created (now referred to as "cal sets"),
the adapter may be removed.
8. Press
MORE
Cal
•
HELP ADAPT REMOVAL
adapter removal technique.)
•
RECALL CAL SETS
•
ADAPTER DELAY
•
ADAPTER COAX
•
ADAPTER WAVEGUIDE
•
REMOVE ADAPTER
9. Press
RECALL CAL SETS
•
RECALL CAL PORT 1
•
RECALL CAL PORT 2
RECALL CAL SETS
file directory.
NOTE In the following two steps, calibration data is recalled, not instrument states.
10.From the disk directory, choose the file associated with the port 1 error correction, then
press
RECALL CAL PORT 1
11.When this is complete, choose the file for the port 2 error correction and press
RECALL CAL PORT 2
12.When complete, press
13.Enter the value of the electrical delay of adapter A3.
Press
ADAPTER DELAY
14.Select the appropriate key:
15.Press
REMOVE ADAPTER
coefficients and overwrite the current active calibration set in use.
This process uses up an internal memory register. The calibration in this register is not
the calibration created by adapter removal, rather it is a "scratch" calibration. You may
6-46.
ADAPTER REMOVAL
(This provides a quick reference guide to using the
to bring up the following two choices:
also brings up the internal (or external if internal not used) disk
.
.
.
RETURN
and enter the value.
ADAPTER COAX
to complete the technique for calculating the new error
Calibrating for Increased Measurement Accuracy
Calibrating for Noninsertable Devices
. This brings up the following menu:
or
ADAPTER WAVEGUIDE
"Modify
.
6-43