Agilent Technologies 8753ET User Manual page 147

Making Mixer Measurements
Fixed IF Mixer Measurements
You may have to consult the user's guide of the external source being used to
NOTE
determine how to set the source to receive SCPI commands.
3. Be sure to connect the 10 MHz reference signals of the external sources to the EXT REF
connector on the rear panel of the analyzer (a BNC tee must be used).
If the 10 MHz reference signals of the external sources are connected
NOTE
together, then it will only be necessary to connect one reference signal from
one of the sources to the EXT REF connector of the analyzer.
Figure 2-21 Connections for a Response Calibration
To enter the following sequence commands that require titling, an external
NOTE
keyboard may be used for convenience.
4. Press the following keys on the analyzer to create sequence 1:
NEW SEQ/MODIFY SEQ
Seq
2-26
SEQUENCE 1 SEQ1