Moving Ahead - Leica TS03 User Manual

Repetitive loop for
the number of sets
7.14.4
Number of defined
sets is achieved
Moving ahead with
the traverse
Apps
Field
F3 Exit Traverse
F4 Back
Alternating between screens for the backsight and foresight measurements
continues according to the configured number of sets.
The number of sets and the face are indicated in the top right corner of the
screen. For example 1/I means set 1 in face I.

Moving ahead

When the number of defined sets is achieved, the Traverse - Select screen is
displayed automatically. The accuracy of the set measurements is checked. The
set can be accepted or redone.
From the Traverse - Select screen, select an option to move ahead with the
traverse, or press ESC to redo the last station.
Field
F1 Survey Sideshot
F2 Move to next Station
F3 Measure Checkpoint
Description
Returns to the Apps Menu. The traverse
stays active and can be continued later. The
data from the last station is lost.
Returns to the previous screen where ESC
was pressed.
Description
Enables the measurement of standard survey
and topographic points. Measured points are
stored with a Traverse flag. If the traverse is
finally adjusted, these points will be updated.
Clo
se
To exit the screen and returns to the
Traverse - Select screen.
Move to the next station. The instrument can
either be left on or turned off. If the instru-
ment is turned off and then turned on again
later, the message Last traverse not yet
finished or processed! Do you really
want to start a new traverse ? All exist-
ing data will be overwritten! will display.
Selecting Yes will re-open the Traverse to
continue at the new station.
The start screen for the next station is similar
to the Enter Station Data screen. The point
ID of the foresight point of the last station is
suggested as station ID automatically.
Run through the loop of backsight and fore-
sight measurements until the number of sets
is reached.
By measuring a check point it is possible to
check whether the Traverse is still within cer-
tain deviations. A check point is excluded
from the traverse calculation and adjustment,
however, all measurement data and results
observed from a check point are stored.
139