Leica TS03 User Manual page 36

Setup step-by-step
Level up with the
electronic level step-
by-step
36
3
2
1
1
1
0016337_001
1. Extend the tripod legs to allow for a comfortable working posture.
Position the tripod over the marked ground point, centring it as best
as possible.
2. Fasten the tribrach and instrument onto the tripod.
3. Turn on the instrument, and, if tilt correction is set to On, the laser
plummet will be activated automatically, and the Level & Plummet
screen appears. Otherwise, press the
and select Level & Plummet.
☞
For TS07, use the optional AutoHeight laser plummet for
vertically setting up the instrument over a ground point
and for measuring the instrument height when setting up
the station.
4. Move the tripod legs and use the tribrach footscrews (a) to centre
the plummet over the ground point (c).
5. Adjust the tripod legs to level the circular level (c).
6. By using the electronic level, turn the tribrach footscrews to precisely
level the instrument. Refer to "Level up with the electronic level step-
by-step".
7. Centre the instrument precisely over the ground point by shifting the
tribrach on the tripod plate .
8. Repeat steps 6. and 7. until the required accuracy is achieved.
The electronic level can be used to precisely level up the instrument using the
footscrews of the tribrach.
1. Turn the instrument until it is parallel to two footscrews.
2. Centre the circular level approximately by turning the footscrews of
the tribrach.
c
7
4/6
5
a
5
b
5
key from within any app
Operation