9
9.1
Description
Creating a codelist
GSI coding
Access
Coding
Coding
Coding
Coding
Codes contain information about recorded points. With the help of coding,
points can be assigned to a particular group simplifying later processing.
Codes are stored in codelists, with each codelist supporting a maximum of 200
codes.
A codelist can be created:
•
on the instrument: Select Manage from the Main Menu. Select Codes
from the Manage Menu.
in Leica Infinity.
•
Codelists can be imported and exported via USB memory stick/SD card or cop-
ied as file between instrument and PC. Refer to "12.3 Importing Data" and
"12.2 Exporting Data".
Number of codes supported in codelists:
Up to 200, when created using Leica Infinity.
•
Codes are always stored as free codes (WI41-49), that means that codes are
not directly linked to a point. They are stored before or after the measurement
depending on the setting made.
A code is always recorded for each measurement as long as the code is dis-
played in the Code: field. For a code not to be recorded, the Code: field must
be cleared. This can be set to occur automatically. Refer to "5.1 Work Settings".
To select a code: On Work Settings, Screen page, configure the survey
•
display so that a Code field is shown. In the survey display, Highlight the
Code field.
Use the right/left navigation key to scroll through the codes.
•
•
Type in a code. After entry, the firmware searches for a matching code
name, and displays these in the code field. If a matching code name
does not exist, then a new code name is created.
Press ENTER to open the codelist.
•
To access a list of codes: Press
•
Key
Description
Cont
To save the changes.
Code in Survey.
153