Inoblender Used As A Stand-Alone Device - Mallinckrodt INOMAX DSir Plus Operation Manual

INOblender Used as a Stand-Alone Device

This section explains how to use the INOblender as a stand-alone device.
Figure 3-3
Figure 3-4
Part No. 20717 Rev-01
2014-07
1
2
3
Typically the INOblender receives INOMAX
from the INOmax DS (INOMAX cylinder
IR
supplies both devices; see Figure 3-3).
As a stand-alone device INOMAX cylinder supplies
just the INOblender. (see Figure 3-4).
1. Disconnect INOMAX regulator hose from
back of INOmax DS .
IR
2. Disconnect INOblender hose from back of
INOmax DS .
IR
3. Connect INOMAX regulator hose to
INOblender inlet hose.
3-5