Table of Contents
Advertisement
Depressurizing the Regulator Supply Line
Depressurizing the regulator supply line removes the buildup of NO
at any time within the next 12 hours. If the regulator supply line is not depressurized, the INOmax DS
be used within 10 minutes after completing pre-use checkout procedure.
2-10
and allows the use of the INOmax DS
2
To depressurize the INOMAX regulator supply line:
1. On the INOMAX cylinder, rotate the INOMAX
cylinder handle clockwise to close the valve.
2. At the back of the INOmax DS
the regulator hose from the INOMAX gas
inlet and connect it to the purge port.
This depressurizes the regulator.
3. When the regulator pressure gauge reads zero,
remove the regulator hose from the purge port
and connect it to the INOMAX gas inlet.
If difficulties are encountered in
Note:
connecting the regulator hose,
refer to page 7-9.
®
IR
must
IR
, remove
IR
Part No. 20717 Rev-01
2014-07
Advertisement
Table of Contents
