Table of Contents
Advertisement
If the INOmax DS
WARNING:
transport mounting post (part number 10009), see Figure 4-13.
Figure 4-13 Universal Mounting Post
The universal mounting post has a machined recess with an integrated cap to prevent twisting or
Note:
accidental release of the device if the mounting clamp assembly becomes loose.
1
Figure 4-14 Transport Mounting Bracket Assembly Attached to Transport Isolette
• When using the transport regulator/cap assembly (PN 10022) ensure the cap is fully seated
Caution:
and in place on the INOmeter and the infrared cable is connected and latched to the infrared
connector port on the back of the INOmax DS
• It is recommended that a second transport regulator/cap assembly is available during all
transports.
Do not attempt to connect the transport regulator/cap assembly electrical plug to the INOblender
Note:
outlet port. This will damage the connector plug electrical pins.
Figure 4-15
4-18
is to be used in a transport vehicle, it should be affixed to the
IR
2
3
1. Transport Isolette
4
2. Isolette Bar
3. INOmax DS
4. Universal Mounting Post
5. Isolette Handle
6. Transport Mounting Bracket Assembly (PN 50041,
5
includes universal mounting post)
6
or INOblender Mounting Area
IR
(see page 4-15).
IR
Part No. 20717 Rev-01
2014-07
Advertisement
Table of Contents
