Mallinckrodt INOMAX DSir Plus Operation Manual page 122

Figure 4-4
Figure 4-5
Figure 4-7
4-14
3. Connect the infrared cable from the transport
regulator/cap assembly to the back of the
INOmax DS
Note:
Caution:
4. Place the cap assembly over the INOmeter
(see Figure 4-5).
Note:
iButton
Figure 4-6
5. Grasp the cap assembly to open cylinder valve
(see Figure 4-7 and 4-8).
Figure 4-8
(see Figure 4-4).
IR
Notice that the connector clicks to indicate
that it is latched in place.
Do not attempt to connect the transport
regulator cap assembly electrical plug
to the INOblender outlet port. This will
damage the connector plug electrical pins.
When using the transport regulator/
cap assembly (PN 10022) ensure
the cap is fully seated and in place
on the INOmeter and the infrared
cable is connected and latched to
the infrared connector port on the
back of the INOmax DS
Be sure to align the keyway inside the
cap assembly with the iButton on the
INOmeter (see Figure 4-5 and 4-6).
The electrical cord exits
the cap directly above
the iButton keyway
-CLOSE +OPEN
.
IR
Part No. 20717 Rev-01
2014-07