Mallinckrodt INOMAX DSir Plus Operation Manual page 139

Alarm
6. Cylinder Not Detected
7. Cylinder Valve Closed
Part No. 20717 Rev-01
2014-07
High Priority Alarms
Possible Cause
Communication between
INOMAX cylinder and
INOmax DS has been lost.
IR
"Delivery Stopped" will occur
1 hour from point when
communication is lost.
a. INOmax DS infrared cart
IR
cable is not connected or
has failed.
b. Interference with the
Infrared communication
link between the
INOMAX cylinder and the
INOmax DS .
IR
c. INOmeter may have failed.
d. Transport Cap not
connected to the INOmeter
"Delivery Stopped" will occur
one hour from point when
cylinder valve is closed.
a. INOMAX cylinder valve is
closed.
b. When two cylinders
are present on the cart,
interference with the
Infrared communication
link between the open
INOMAX cylinder and the
INOmax DS may result
IR
in a cylinder valve closed
alarm.
c. INOmeter may have failed.
Recommended Action
All of these actions can be performed while
delivering INOMAX to the patient:
Confirm infrared cart cable is connected to
infrared connector on back of INOmax DS
1. Remove obstruction between INOmeter and
INOmax DS cart transceiver.
IR
2. Move interfering light source or reposition
cart to reduce high intensity light in area of
INOmeter.
Replace INOMAX cylinder on cart.
If utilizing a transport regulator/cap assembly:
1. Connect transport regulator/cap assembly
cable to infrared connector on back of
INOmax DS .
IR
2. Confirm transport cap assembly is over
INOmeter.
3. Replace transport regulator/cap assembly.
4. Replace INOMAX cylinder.
Contact Technical Support.
All of these actions can be performed while
delivering INOMAX to the patient:
1. Open INOMAX cylinder valve.
2. If cylinder valve is open, confirm that it has
been opened fully.
Reposition INOmax DS cart, remove any
IR
obstacle between INOmeter and cart.
Replace INOMAX cylinder.
Contact Technical Support.
.
IR
5-9