Table of Contents
Advertisement
PDI Super Sani Cloth by PDI
Sani Cloth HB by PDI
Asepti-HB by Ecolab Inc.
Cavicide and CaviWipes by Metrex
Cleaning Water Trap Bottle
If alcohol is used to clean water trap bottle, make sure alcohol is completely evaporated before
Caution:
placing back onto sample block.
• Alcohol vapors will cause NO
to read low (approximately 0.5 to one ppm).
• This is a transient response and will stop once alcohol vapors dissipate (trap dries out).
Procedure
• Clean water trap bottle with a soft cloth dampened in a mild soap and water solution or with isopropyl alcohol (70%).
• Allow water trap bottle to air dry.
Bioquell Hydrogen Peroxide Sterilant
Bioquell Hydrogen Peroxide Sterilant and hydrogen peroxide vapor generators are regulated by the US
Environmental Protection Agency (EPA) as pesticide chemicals in accordance with Federal Insecticide,
Fungicide, and Rodenticide Act (FIFRA). Use of these products in cleaning/disinfection processes have not been
validated with the INOmax DS
products used with the INOmax DS
Part No. 20717 Rev-01
2014-07
sensor to read high (as much as six ppm) and NO sensor
2
. Do not use these products to decontaminate the INOmax DS
IR
.
IR
n-Alkyl (68% C12, 32% C14) dimethyl ethylbenzyl
ammonium chlorides 0.25%
n-Alkyl (60% C14, 30% C16, 5% C12, 5% C18)
dimethyl benzyl ammonium chlorides 0.25%
Isopropyl alcohol 55%
Inert ingredients 44.50%
n-Alkyl (60% C14, 30% C16, 5% C12, 5% C18)
dimethyl benzyl ammonium chlorides 0.07%
n-Alkyl (68% C12, 32% C14) dimethyl ethylbenzyl
ammonium chlorides 0.07%
Inert ingredients 99.86%
n-Alkyl (60% C14, 30% C16, 5% C12, 5% C18)
dimethyl benzyl ammonium chlorides 0.07%
n-Alkyl (68% C12, 32% C14) dimethyl ethylbenzyl
ammonium chlorides 0.07%
Inert ingredients 99.86%
Diisobutylphenooxyethoxyethyl dimethyl benzyl
ammonium chloride 0.28%
Isopropyl alcohol 17.2%
Inert ingredients 82.52%
or any ancillary
IR
7-3
Advertisement
Table of Contents
