Depressurizing the Regulator Supply Line
Part No. 20568 Rev-02
2015-08
To depressurize the INOMAX regulator supply line:
1. On the INOMAX cylinder, rotate the INOMAX
cylinder handle clockwise to close the valve.
2. At the back of the INOmax DS
remove the regulator hose from the INOMAX
gas inlet and connect it to the purge port.
This depressurizes the regulator.
3. When the regulator pressure gauge reads zero,
remove the regulator hose from the purge port
and connect it to the INOMAX gas inlet.
If difficulties are encountered in
Note:
connecting the regulator hose,
refer to Section 6/Maintenance.
Plus MRI,
IR
2-11